|
This unit has the following configuration:
- 2 input channel, 10 output channel, E config.
- Input and output port type: Both bulkhead on front
- Fiber type: 9/125um
- Return Loss: typical, >65dB
- wavelength range: 1270 to 1670nm
- Connector type: SM, FC/APC
General Info: The JDS Uniphase SB, SC, and SCG series of Benchtop/Rackmount Programmable Switches can be controlled using the front panel keys and a numeric pad or via GPIB and serial RS232 interface. The SCG series ganged input switches allow a single switch instrument to replace multiple switch elements while maintaining low loss. In this series of switches, the inputs are ganged together in a particular sequence and are thus able to offer three different modes of operation (D, E, and F configurations).
The SB and SC series switches are available in four basic configurations, namely C, D, E, and F. The C configuration is a single common input model. The D configuration provides simultaneous connection of a bank of input fibers to output fibers. The E configuration allows any input to be connected to any output while other inputs/outputs are aligned to subsequent/adjacent channels. The switch is non-blocking in this mode and other inputs/outputs are aligned. The F configuration enables one of the inputs to be aligned with an output in a blocking sense, with a result in reduction of available output channels. A low-loss MxN blocking switch is the result.
Key Features
-
SB switches can accommodate up to 48 channels
-
SC switches can accommodate up to 180 channels
-
SB and SC series switches offer up to four input channels
-
Low insertion loss, 0.4 dB typical
-
Excellent repeatability, 0.003 dB typical
-
High return loss,> 65 dB typical
-
GPIB and RS232 remote control
-
Complies to CE requirements plus UL3101-1 and CAN/CSA-C22.2 No. 1010.1
| 
